Home > Gardening > 7 easy steps to install landscaping drainage pipe

7 easy steps to install landscaping drainage pipe

landscaping garden

For homeowners, a working landscaping drainage system is an important matter because poor drainage can mean serious trouble in the long run. Just imagine how burdensome and stressful it would be dealing with the absence of landscaping drainage pipes. The lack or poor drainage system in existence may result to mud and ruined turf, foul offensive odor, creepy insects and dying plant roots.

Planning and installing drainage will solve the dilemma. This will also prevent the area from becoming a maintenance mayhem after a storm during the rainy seasons.

Why Drainage System Planning Is Important?

Planning is a very crucial part of any project, especially your landscaping pipe works. This step in your project will determine the success or failure of this endeavor. Drainage pipe installation can be a difficult and physically demanding job. But with the right machinery, you don’t have to exert much effort to carry out this project.

An underground plumbing system must travel from the highest point of your property to the lowest point in a steady slope. This is an effective way of preventing any pooling of water in the future.

Follow our easy seven-step installation guide for your drain pipes:

Step 1: Determine and decide the exact route where water can pass through. The route of the drainage pipe must be direct. This will be an easier process if you deter water coming from a certain area.

Step 2: Choose the pipe you wish to use. You have to purchase a closed pipe to divert running water away from the majority of the property area. This type of pipe allows the water to flow through and through.

The closed drainage pipe can be found in bendable rolls which is available in several yards along with all the fittings needed to join as many lengths as needed. If you are trying to get rid of water from the general area, secure pipes that are open. This type most oftentimes has holes down the length and comes in specific short sections and not as a kit.

planning

Step 3: Start digging the drench. As you can see, the drainage pipes must be set in a drench. You can dig the drench in the route which you have decided the pipes to be. The dimension of the trench must be 18 inches deep and 8 to 10 inches in width.

When you shovel the sod to begin with the trench, you can keep it. You will later need it to cover the direction where you want the water to end up. How deep and shallow the trench at certain points is all dependent on the contour of the land. However, you must remember that the bottom part should be downgraded consistently.

Step 4: Make use of gravel to line the trench with just a couple of inches of gravel and level it off. Use filter fabric over the trench for open drainage piping system.

Step 5: You are now ready to install the pipes. You can unroll the reels to the closed pipe system into the trench. If there is the presence of a drain which you must connect at the beginning of the entire trench, be sure that you attach it appropriately. If you opt for an open system pipes, you should lay it down at the bottom of the trench. The holes must be facing downwards. The filter fabric must be wrapped around the pipe as the work progresses. The filter fabric will make sure that drainage pipe does not get clogged up by too much debris which can be washed into it during a storm.

Step 6: This time you have to refill the trench back. Once you have laid down the piping, confirm that the downgrade is continuous and steady for the entire span of the system. Fill the trench thoroughly. Remember to never disturb the pipeline which you have installed. The filter fabric must never be disturbed once you fill in the trench.

Step 7: The sod should be replaced appropriately. Give your drainage system a neat finish. The sod which you set aside while you were digging for the trench must be put back into place.

The installation of a drainage pipe system can be labor-intensive. The steps we come up with is very useful for those who would want to put their DIY skills to the test. However, for those home owners who lack the confidence in digging their own pipes, they can always hire experts from plumbing services Sydney area.